The Monoblock is engineered to be mounted directly to the holster body or other solid surface. Recommended hardware configuration from top to bottom: Screw, steel washer, Monoblock clip, body of the holster. The nut is placed on the inside. For some applications, the metal washer can be placed behind the clip or may not be used at all. Please verify clearances to ensure the square nut is compatible with your specific holster brand and recessed enough to not protrude inside the body.
Features/Specifications:
- 2.73" OAL
- Fits over belts up to 1.5"
- (2) .220"H x .300" W horizontal slotted mounting holes will work with spacing that is .860" - 1.15" on center.
- Our surface finish comes standard in our shade of DCC Gray CERAKOTE® ceramic, stacked on top of a corrosion-inhibiting pretreatment. Aside from fantastic cosmetics, the result is a non-reflective, highly corrosion-resistant, and highly abrasion-resistant coating.
- Works with or without a belt.
- Hardware not included. It is available separately on this page as an add on option.
- (2) Low profile 1/4” Chicago Screws brand combo screws with reusable thread patching (pre applied threadlocker)
- (2) steel washers
- (2) steel square nuts makes it easy to counter hold with a wrench or your fingers in tight areas
- Standard DMG/Cu finish on all components: Color - DCC dark matte grey. Non reflective and resists corrosion very well
- Once assembled, always double check clearances to ensure the nuts or screws will not contact your equipment before use
